Artikelbeschreibung
Zenith CH801 STOL Experimental
For specification and videos please google.
Kit from Year 2000, build started 2018 with Austrocontrol supervision.
Fuselage: ready built, some rivets need to be installed for better accessibillity during final build.
Windshield and top shield needs to be installed.
Doors with locks ready built but not fitted to fuselage yet.
Wings: ready and fitted to struts and fuselage. All electrical wiring, fuel connection and pitot in wing done. Final alignment of alusheet to fuselage needs to be done. Jury struts not fitted yet.
Slat: ready built and fitted
Ailerons: ready built, parts need to be fitted to wing and controls
Rudder: ready installed and finnished with car foil
Elevator: ready installed and partly finished with car foil
Seats: ready for upholstery
Complete kit with dokumentation, all components built to highest standards by experienced amateur builder, all contact surfaces corrosion treated.
Options bought 2018 or later
HD Tail: larger elevator ready installed and partly finished with car foil
Extended Range Tanks: 2 additional tanks in wings with Faucet fuel transfer pumps. Ready installed and connected.
Dual Control Sticks: ready installed
Dual Brake Kit: ready installed
Bubble Window Kit: ready installed in doors
Wing stiffener in fuselage: fitted (precautionary)
Spring For Nosewheel: Viking replacement for bungee in nosewheel- installed
Engine cowling: for O-360, 3hole not installed, loose on board
Dynon GPS 2020 ADS-B Antenna: installed
Dynon Autopilot Servo SV 42: installed elevator
Dynon Autopilot Servo SV 42: not installed for ailerons, loose on board. Installation possible only after fitting ailerons to wing and fuselage
Dynon Heated Pitot with stall warning: installed
Dynon Primary ADAHRS: not installed, loose on board
TED XPDR Antenna: installed
VHF TRIG TY 91: for Dynon 8.33 khz radio installed
VHF Antenna: installed
Landing lights: installed and wired in slats
Strobes: installed and wired in wings and rudder
Asking price far below parts price. All parts bought new for this project.
